Jesi upucao najnoviji firmware?
Rangelink Revision History
-----------------------rangelink tx-------------------------
Firmware:
v1.03 First Customer Release.
v1.26
1.fixed interference with vrx 1.2GHZ system.
2.support futaba radio 12ch ppm mode (only at teacher mode).
{Only tested with 12FG}
v1.27 add new feature link quality indicator / rf rssi indicator selectable (on rssi pin)
-----------------------rangelink rx-------------------------
Firmware:
v1.06 First Customer Release.
v1.23
1.change rssi(packet rate) to rf rssi. range (0-3.2V)
2.reduce the fs setting request(3-6s).
Hardware:
New batch<after 2012-03> change the internal buffer, improve the driving circuit capacity. and improve the internal RC filter, because some OSD input very low impedance,like eagletree OSD PRO less 5Kohm. and some OSD input not include filter (HW filter or digital filter), so it will make the rssi unstabitily.
v1.24 add new feature link quality indicator / rf rssi indicator selectable. (rssi pin)
Note: if you wanna to upgrade,please upgrade both(tx & rx) to the newest version.
New feature link quality indicator / rf rssi indicator selectable:
make rangelink tx enter advanced binding mode, first beep end:
the two ways switch
high power mode ==> link quality indicator
low power mode ==> rf rssi indicator
Topic: Problem sa Rangelinkom (Read 7230 times)
previous topic - next topic
